The main reason for the low efficiency of dehumidification is the improper maintenancejiu0 edited on2017-05-24 02:58:25 184 views
The main reason for the low efficiency of dehumidification is the improper maintenance
The working effect of dehumidifier is not ideal, and the quality of dehumidifier is not big.
Why do you say that? Dehumidification effect is not ideal because of dehumidifier,
The reasons are manifold, except for quality reasons,
Most of the time, the maintenance is not good, resulting in inefficient dehumidifier.
We don't have to pay attention to the dehumidifier that is leaking fluoride, because the dehumidifier doesn't work at all.
Dehumidification efficiency is low, mainly for the following reasons:
Whether the humidity adjusting switch 1, humidity, air filter is clogged,
This is very important, as soon as the incoming wind is affected, the dehumidification effect is very poor;
Check if there is dirt on the evaporator, corrosion, and cleaning if necessary.
2 、 before the dehumidifier inlet, is there any obstacle?. Is the temperature in the room increasing or decreasing all the time?.
(low temperature, will affect the dehumidification effect, or even dehumidification,
If the room temperature is low, you can use the heater heating, improve indoor temperature, to achieve good dehumidification effect. )
3, room doors and windows are closed, the air flow is located in the "low wind" position,
The utility area of the dehumidifier does not correspond with the actual use area.
The house area is too large, and the dehumidifier is too small,
Are there plenty of moisture sources in the house?,
Are there a lot of moisture absorbing products in the house? Are there any ventilation or fresh air systems?.
4 、 does the heat exchanger of the dehumidifier have clogging?.
5, dehumidifier whether there is leakage of fluorine, lack of refrigerant, if the leakage of fluorine, will not dehumidification.
So many reasons, dehumidification efficiency is low, how should we maintain good dehumidifier?
1, should be placed in the central position of the indoor dehumidifier. The body should be flat, not tilted or upside down.
2, use doors and windows as close as possible, so that indoor dehumidification effect.
3, the ambient temperature is lower than 15 DEG C, attached to the evaporator surface water will freeze and make the weakening effect of dehumidifier,
If the ambient temperature is above 40 degrees Celsius, the pressure in the system will increase and the compressor will be overloaded,
At this point, the overload protector will cut off the line and stop working.
Therefore, the optimum temperature range of dehumidifier is between 15 and 40 degrees centigrade.
4, dehumidifier air inlet and outlet can not have obstacles blocking, air filter net should be cleaned.
5, dehumidifier, water storage is full, the machine will stop automatically, avoid the Overflow Pollution wet ground.
6, dehumidifier condenser should always clean, keep clean.
Timing (about two weeks at a time) cleaning gas filter network, in order to maintain the machine's good dehumidification, dust removal efficiency and long life guarantee.
Clean the body, gently wipe with a damp cloth to clean water; do not directly, lest the electrical components wet short circuit.
7, dehumidifier after moving, it is best to advance static pendulum four to six hours, and then boot,
Because the dehumidifier compressor pipeline contains cold coal, after moving,
The refrigerant should return to its original position after four to six hours.
8, the body surface adhesion, can be washed with soapy water,
Do not spray with gasoline, petroleum extracts, solvents, or spray pesticides, or paint or discolor.
9, do not use fine sticks, wire to dig inside the machine, to avoid failure or danger.
10, power outages or long-term need not, when traveling,
Please unplug the power cord and pack it separately to extend the life of the machine.
published on：20170524 02:58:01 guangzhou